Home / Support / Electronic / Kwikset Convert Smart Lock Conversion Kit with Z-Wave Technology
Support
Discontinued
Finishes
- Venetian Bronze
- Lifetime Polished Brass
- Satin Nickel
View in Product Catalog
Ask A Question Register Product
Documents
Note: Do not use prints from this website to mark distances. Due to individual printers, dimensions on installation instructions may not print at an accurate scale.
Answers
Support answers found: 4
Choose a Topic
- Battery
-
Answer Add the lock to your smart home system Initiate the process to add the lock to your system at your smart home controller. Refer to your smart home system instructions for more information. When prompted by your smart home system to add the lock, press button “A” on the lock interior one time. The red LED will illuminate when the lock enters Add Mode. Please allow time for the controller to add the lock. If successful, re-name the lock in your system (if applicable). If unsuccessful, follow your system's instructions to remove the lock from the controller and any other network, then press button “A” on the lock one time. Perform steps 7A-7C again. Read More -
Answer Troubleshooting: Adding the Lock to a Smart Home SystemSome Z-Wave® systems require that the lock be within 12" of the controller during the adding process. If this is the case, follow the steps below to remove the lock interior from the door to perform the process closer to the controller:1. Remove the small screws that secure the interior assembly to the mounting plate.2. Remove the interior assembly from the door.3. Hold the interior assembly a maximum of 12" (305 mm) from your smart home controller for the rest of this process.4. Initiate the process to add the lock to your system at your smart home controller. Refer to your smart home system instructions for more information.5. When prompted by your smart home system to add the lock, press button “A” on the lock interior one time. The red LED will illuminate when the lock enters Add Mode. Please allow time for the controller to add the lock.6. Once successful, re-name the lock in your system (if applicable). Then, reinstall the lock interior on the interior assembly Read More -
Answer Amber flash - Door is locked.Green flash - Door is unlocked.Red flash - The 4 AA batteries in the interior are low and need to be replaced. Read More -
Answer 1. Status LED - Door lock status LED blinks every 6 seconds. ON position is factory default.2. Auto-Lock - Automatically re-locks door 30 seconds after unlocking. OFF position is factory default. 3. Audio - Beeping sound is heard during programming and normal operation. ON position is factory default. 4. Invert - Only used if the Status LED is communicating the opposite door lock status. Read More
Community Q&As
{{/each}}